Dss-networks 5161 Manual do Utilizador descarregar pdf (Página 21)

GigMAC PMC and PCI Board and Driver Users Manual

LOADING THE DRIVER FOR INTEL BASED MODELS (5261, 5262, 5164, etc.)

Note: In order to load the Intel driver, the "ChipSelector=1" option is required

during the 'insmod' as follows:

insmod ./dpm.o ChipSelector=1

TUNING THE INSTALLATION

Interrupt holdoff (programmed latency)

To increase (or decrease) the value of the programmed interrupt latency, insert

the module and set the "IntrHoldOff" parameter as follows:

insmod ./dpm.o IntrHoldOff=1 # value can be 0, 1, 2 or 3

Note: A value greater than 3 is not recommended.

Other driver parameters that can be set during driver load or in

modules.conf:

MediaSpeed=10,100,1000 # Media Speed (default 1000)

SetAutoNeg=0,1 # Setting for auto negotiation (default 1=auto)

DuplexMode=0,1 # Setting for duplex (default 1=FULL)

IntrHoldOff=0,1,2 # interrupt holdoff value in 100 microsecond

units

ChipSelector=0,1 # default=0 (National), 1=Intel

NumBufDescs=<cnt> # default=256, 128, 256, 512, 1024

MaxBufferSize=<size> # default=2048, 2048, 4096, 8192

FrameGenSize=<size> # frame generator test size (64-9000 bytes)

See “Command Line Parameters” table below for additional information on driver

module insertion parameters.

DSS NETWORKS, INC.

Version: 2.0 Page: 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 32 33

Sem comentários

Dss-networks 5161 Manual do Utilizador Página 21